Bits and bobs

The validation test run gave the expected result - the code is fine, it really was just coincidence that all seven runs happened to suffer catastrophic errors due to mistakes with maintainance of the Keter mainframe! Idiots!

If it happens again...

At least all can be set off again. Now the task is to keep running these things until they finally agree to output something sensible... like results... Then again, I've been doing this for a year now...

A second program has given up its secrets - the chemistry module's apparent inability to do anything between a quick rough and ready run and an overlong run is down to one step where the log of the H2 density is taken and raised to an integer power of ten. Unfortunately, the natural logarithm had been taken, which effectively doubles what the log should've been... now that is corrected, I can fine tune it a little better. I hope... Then I'll be out of the situation where a small number of low lying high density regions fail to run whilst everything else goes fine...

All alpha runs dead as predicted. They're next for the change...

Chemistry is better, but not yet as it should be. I get results up and down the range, but a few are still a little too coarse. They will be sorted once again...

Alphas have all been recoded and set off once more. Chapter three's final bit may even get done! Assuming they ever leave this queue...

ok, some are off...

Couple of checks on Chapter five done

Chemistry module finished. H2 problem still there. Most confusing... will sort out another day